Round-the-Clock Emergency Response
The first few hours decide how large the job becomes. Water wicks up drywall, swells particleboard subfloors, and soaks into carpet pad faster than most people expect. Within a day or two, a clean-water loss can turn into a mold job. That is why the line is staffed around the clock and why emergency calls go straight to the contractor on duty closest to your road.
On an emergency visit, the crew that arrives typically starts with source control and safety. They verify the supply is off, kill any circuits sitting near water, and get extraction going with portable or truck-mounted equipment. When there is standing water below grade, a submersible trash pump usually goes in before anything else. Next comes a round of moisture readings, a thermal imaging pass to map where water spread, and the initial set of air movers and LGR dehumidifiers.
By the end of the first visit, you should know a few things clearly. You should know which rooms are wet, what category of water is involved, and which materials can be dried in place versus removed. You should also have a return time for the next round of readings and equipment adjustments. Three to five days of drying is typical, but hardwood floors, plaster walls, and stone foundations can stretch that out. Keep the machines on, the windows closed unless the pro says to open them, and the thermostat where it was set.
- Burst pipes, broken supply lines, and leaking water heaters
- Storm runoff, roof leaks, and flooded window wells
- Sump pump failures and basement seepage
- Overnight and holiday calls handled the same way




